Hyundai Elantra

since 2000-2004 of release

Repair and car operation



Elantr's Hyundai
+ Petrol engines 1,6, 1,8 and 2,0 of l
+ Diesel engine of 2,0 l
+ greasing System
+ cooling System
+ Fuel system
+ Monitoring systems and decrease in toxicity of the fulfilled gases
+ ignition System
+ System of preliminary heating of the diesel engine
+ Coupling
+ Mechanical transmission
+ Automatic transmission
+ Power shafts, forward and back axes
+ Suspension bracket
+ Steering
+ Brake system
+ Body
+ air Central air
- Electric equipment
   Specifications
   Charging system
   Generator
   Power failure check on a wire connecting the storage battery to the generator
   Check of the current developed by the generator
   Check of developed tension
   Generator of petrol engines
   Generator of the diesel engine
   Storage battery
   Start system
   Starter of petrol engines
   Starter of the diesel engine
   Safety locks
   Block of safety locks
   Multipurpose switch
   Sound signal
   Combination of devices
   Switch of position of the parking brake
   Screen wiper and stekloomyvatel of a windscreen
   Screen wiper of back glass
   Headlights and forward indexes of turn
   Forward fog lights and turn repeaters
   The back combined lamp
   Top stoplight
   Lamp of illumination of registration plate
   The ceiling lamp (with the hatch)
   The ceiling lamp (without the hatch)
   Lamp of illumination of salon
   Check of the relay of headlights
   Radio receiver
   Heater of back glass
   Safety cushions (SRS)
   Seat belts
   Search and elimination of malfunctions
   Specification for adjustments and control
Electric circuits



Seat belts


Prednatyazhitel of a seat belt

When the car has an accident under a certain corner in relation to face-to-face blow, the gas generator ignites a signal from the SRSCM block.

The gas leaving a gas generator will cause piston moving in the cylinder with a tooth gearing of a prednatyazhitel.
The tooth gearing rotates a piston gear wheel, and the satellite rotates planetary gear wheels.

As a result of it the belt stretches at the expense of drum rotation. Therefore, the belt with a prednatyazhitel reduces weight of a travmirovaniye of the driver and the forward passenger at the expense of a preliminary tension of a belt. It interferes with moving of the driver and the forward passenger forward and excludes blow about a steering wheel or the dashboard.

The loading limiter from seat belts

The limiter of loading is intended for reduction of force of blow of the driver and the forward passenger about the fastened seat belts during collision. If force of collision reaches some size, торсион previously the tense seat belts is deformed and slightly releases a seat belt, reducing force of blow.

Removal

 PERFORMANCE ORDER

    Disconnect a wire from the negative plug of the storage battery.

Before service of system of safety cushions be convinced that passed not less than 30 with the ambassador of switching off of ignition and a wire detachment from the negative plug of the storage battery.

    Turn out screws of fastening of an overlay of a threshold.
    Turn out a bolt of the bottom fastening of a forward seat belt and an edge of a flat screw-driver lift up and remove an upholstery of an average rack.
    Turn out a bolt of the top fastening of a forward seat belt.
    Turn out a bolt of fastening of a natyazhitel of a forward seat belt and remove a belt from the car.

  1. Do not assort and do not repair the module of a prednatyazhitel of a seat belt.
  2. Do not drop the module of a prednatyazhitel of a seat belt and do not allow its contact to water, greasing etc. If dents are found, cracks, deformation or corrosion, replace the module.
  3. Do not subject the module of a prednatyazhitel of a seat belt to influence of temperatures above 93°С.
  4. The module of a prednatyazhitel of a seat belt works only once.
  5. At utilization of the worked module use goggles and gloves.