Hyundai Elantra

since 2000-2004 of release

Repair and car operation



Elantr's Hyundai
+ Petrol engines 1,6, 1,8 and 2,0 of l
+ Diesel engine of 2,0 l
+ greasing System
+ cooling System
+ Fuel system
+ Monitoring systems and decrease in toxicity of the fulfilled gases
+ ignition System
+ System of preliminary heating of the diesel engine
+ Coupling
+ Mechanical transmission
+ Automatic transmission
+ Power shafts, forward and back axes
+ Suspension bracket
+ Steering
+ Brake system
+ Body
+ air Central air
- Electric equipment
   Specifications
   Charging system
   Generator
   Power failure check on a wire connecting the storage battery to the generator
   Check of the current developed by the generator
   Check of developed tension
   Generator of petrol engines
   Generator of the diesel engine
   Storage battery
   Start system
   Starter of petrol engines
   Starter of the diesel engine
   Safety locks
   Block of safety locks
   Multipurpose switch
   Sound signal
   Combination of devices
   Switch of position of the parking brake
   Screen wiper and stekloomyvatel of a windscreen
   Screen wiper of back glass
   Headlights and forward indexes of turn
   Forward fog lights and turn repeaters
   The back combined lamp
   Top stoplight
   Lamp of illumination of registration plate
   The ceiling lamp (with the hatch)
   The ceiling lamp (without the hatch)
   Lamp of illumination of salon
   Check of the relay of headlights
   Radio receiver
   Heater of back glass
   Safety cushions (SRS)
   Seat belts
   Search and elimination of malfunctions
   Specification for adjustments and control
Electric circuits



Screen wiper and stekloomyvatel of a windscreen

Removal

 PERFORMANCE ORDER

    Remove covers and turn out nuts of fastening of levers of a screen wiper. Remove screen wiper levers.

At removal of levers of screen wipers do not scratch a cowl.

    Uncover, located under a windscreen.
    Disconnect the socket and remove the engine and drafts of a screen wiper. Inhaling moment: 7–11 N • m.

Installation

 PERFORMANCE ORDER

    Establish the screen wiper lever in a certain situation.
Provision of installation of the lever of a screen wiper
And
In
Distance, mm
35±5
35±5
    Adjust nozzles of sprays so that they sprayed liquid in strictly certain places on a windscreen.

Check

Check conductivity between contacts of the socket of the switch of a cleaner and a windscreen washer. If conductivity does not correspond demanded, replace the switch of a cleaner and a windscreen washer.

Switch of a screen wiper (M01-1)

Switch of a stekloomyvatel (M01-1)

Check of frequency of work of a screen wiper

 PERFORMANCE ORDER

    Disconnect the socket from the screen wiper engine. Additional wires connect the positive plug of the storage battery to the plug 4 sockets, and the negative plug – to the plug 1. Be convinced that the engine of a screen wiper works at low frequency of rotation. Additional wires connect the positive plug of the storage battery to the plug 4 sockets, and the negative plug – to the plug 2.
    Be convinced that the engine of a screen wiper works at high frequency of rotation.

Check of an automatic stop of brushes in an initial condition

 PERFORMANCE ORDER

    Turn on the engine on low frequency of rotation. Having disconnected a wire from the plug 3 sockets, stop the engine in any situation, except the initial. Connect socket plugs 1 and 5. Additional wires connect the positive plug of the storage battery to the plug 4 sockets, and the negative plug – to the plug 3.
    Check that the engine of a screen wiper is switched off in a starting position of brushes of a screen wiper.

Check of operation of the engine of a stekloomyvatel

 PERFORMANCE ORDER

    With the engine of a stekloomyvatel connected to a washer tank, fill a tank of a stekloomyvatel with water. Additional wires connect the positive plug of the storage battery to the plug 2 sockets, and the negative plug – to the plug 1, thus the engine should work, and the pump to swing water.