Hyundai Elantra

since 2000-2004 of release

Repair and car operation


Elantr's Hyundai
+ Petrol engines 1,6, 1,8 and 2,0 of l
+ Diesel engine of 2,0 l
+ greasing System
+ cooling System
+ Fuel system
+ Monitoring systems and decrease in toxicity of the fulfilled gases
+ ignition System
+ System of preliminary heating of the diesel engine
+ Coupling
+ Mechanical transmission
+ Automatic transmission
+ Power shafts, forward and back axes
+ Suspension bracket
+ Steering
+ Brake system
+ Body
+ air Central air
- Electric equipment
   Specifications
   Charging system
   Generator
   Power failure check on a wire connecting the storage battery to the generator
   Check of the current developed by the generator
   Check of developed tension
   Generator of petrol engines
   Generator of the diesel engine
   Storage battery
   Start system
   Starter of petrol engines
   Starter of the diesel engine
   Safety locks
   Block of safety locks
   Multipurpose switch
   Sound signal
   Combination of devices
   Switch of position of the parking brake
   Screen wiper and stekloomyvatel of a windscreen
   Screen wiper of back glass
   Headlights and forward indexes of turn
   Forward fog lights and turn repeaters
   The back combined lamp
   Top stoplight
   Lamp of illumination of registration plate
   The ceiling lamp (with the hatch)
   The ceiling lamp (without the hatch)
   Lamp of illumination of salon
   Check of the relay of headlights
   Radio receiver
   Heater of back glass
   Safety cushions (SRS)
   Seat belts
   Search and elimination of malfunctions
   Specification for adjustments and control
Electric circuits


Multipurpose switch

Removal and installation

At removal of the multipurpose switch on the cars equipped with a safety cushion, be careful and satisfy the following conditions.

  1. Do not assort any of components of auxiliary system of safety of SRS. Dismantling of components can put safety system out of action.
  2. Exclude hit on a safety cushion of solvents or clearing substances.
  3. Transport a safety airbag separately, a bag up.
  4. If any SRS component fell or on it there are cracks, dents or other defects in the case, an arm or the socket, replace them with the new.
  5. At transportation do not place a hand on a safety cushion.
  6. Do not heat up the safety cushion block to temperatures above 93°C.
  7. After expansion of a safety cushion replace a spiral spring of the sensor with the new.
  8. Before installation of a spiral spring of the sensor of a safety cushion combine a label and the index of neutral provision of a spring of the sensor, previously having established forward wheels for movement directly forward. If the label of a spiral spring is not combined properly, the steering wheel cannot turn completely or the wire of a spiral spring will be damaged, complicating normal work of SRS.

 PERFORMANCE ORDER

    Remove a safety cushion of the driver.
    Remove a steering wheel.
    Turn out screws and remove the top and bottom casings of a steering column. Turn out screws and remove the multipurpose switch.
    Installation is carried out to sequences, return to removal.

Check

With the multipurpose switch in each situation check conductivity between the corresponding contacts of sockets. If conductivity does not correspond demanded, replace the multipurpose switch.

Lighting switch (M01-2 socket)

Switch of light of headlights (M01-2 socket)

HU: driving beam of headlights
HL: passing beam of headlights
P: dimensional lighting

Turn switch (M01-2 socket)

Screen wiper switch (M01-1 socket)

Switch stekloomyvatel (M01-1 socket)

Switch of forward fog lights (M01-2 socket)