Elantr's Hyundai
+ Petrol engines 1,6, 1,8 and 2,0 of l
+ Diesel engine of 2,0 l
+ greasing System
+ cooling System
+ Fuel system
+ Monitoring systems and decrease in toxicity of the fulfilled gases
+ ignition System
+ System of preliminary heating of the diesel engine
+ Coupling
+ Mechanical transmission
+ Automatic transmission
+ Power shafts, forward and back axes
+ Suspension bracket
+ Steering
+ Brake system
+ Body
+ air Central air
- Electric equipment
Specifications
Charging system
Generator
Power failure check on a wire connecting the storage battery to the generator
Check of the current developed by the generator
Check of developed tension
Generator of petrol engines
Generator of the diesel engine
Storage battery
Start system
Starter of petrol engines
Starter of the diesel engine
Safety locks
Block of safety locks
Multipurpose switch
Sound signal
Combination of devices
Switch of position of the parking brake
Screen wiper and stekloomyvatel of a windscreen
Screen wiper of back glass
Headlights and forward indexes of turn
Forward fog lights and turn repeaters
The back combined lamp
Top stoplight
Lamp of illumination of registration plate
The ceiling lamp (with the hatch)
The ceiling lamp (without the hatch)
Lamp of illumination of salon
Check of the relay of headlights
Radio receiver
Heater of back glass
Safety cushions (SRS)
Seat belts
Search and elimination of malfunctions
Specification for adjustments and control
Electric circuits
|
Block of safety locks
Removal
|
|
Disconnect a wire from the negative plug of the storage battery.
|
|
Turn out screws of fastening of the bottom decorative panel located under the dashboard.
|
|
|
Turn out screws of fastening of the lateral decorative panel and remove it from the dashboard.
|
|
|
Remove an arm of support of the dashboard from the driver.
|
Disconnect sockets from the block of safety locks.
|
|
Check
|
|
Be convinced that safety locks are reliably fixed in the nests.
Be convinced that the rated current of a safety lock corresponds to a chain which it protects.
|
|
Check integrity of safety locks. If it is necessary to replace a safety lock use a new safety lock of the demanded capacity. Always define the reason of a peregoraniye of a safety lock and before installation of a new safety lock eliminate a malfunction source.
|
|
|
The electric chains protected by safety locks and burned-through crossing points, located in a motor compartment
|
Contour
|
Current, And
|
| Storage battery |
50
|
| Generator |
100
|
| Kondensor |
20
|
| Ignition |
30
|
| ABS 1 |
30
|
| ABS 2 |
20
|
| Radiator |
20
|
| ЕСМ |
20
|
| Fan |
30
|
|
|