It is expected that the key from the lock of ignition cannot be removed from the lock cylinder to a detachment of a cable of blocking from the lock. For an exception of these problems at repair and service carry out the following recommendations.
Assembly of a cable of blocking and ignition lock
The lock of ignition is established on a steering column. Turn a key in the ignition lock in the provision of blocking of "LOCK".
The screw connect a cable of blocking and the ignition lock.
Assembly of a cable of blocking and gear shifting lever
Establish the selector lever in the situation "P".
b. After installation of a cable of blocking, as is shown in drawing, weaken nut М8 of fastening of a plate of a cable of blocking so that the plate could be turned after applying of a certain effort.
c. Turning a plate with the fixed cable in the direction "F", eliminate cable sagging in «B» point. At elimination of sagging do not pull a cable in the direction "X" as thus the key can not leave the cylinder of the lock of ignition. d. Tighten a nut of M8 of fastening of a cable of blocking.