Hyundai Elantra

since 2000-2004 of release

Repair and car operation



Elantr's Hyundai
+ Petrol engines 1,6, 1,8 and 2,0 of l
+ Diesel engine of 2,0 l
+ greasing System
+ cooling System
+ Fuel system
+ Monitoring systems and decrease in toxicity of the fulfilled gases
+ ignition System
+ System of preliminary heating of the diesel engine
+ Coupling
+ Mechanical transmission
- Automatic transmission
   Specifications
   Check of level of liquid in an automatic transmission
   Liquid replacement in an automatic transmission
   Check of conductivity of the switch of ranges of a transmission (F4A42)
   Switch of ranges of a transmission and adjustment of a cable of management (F4A42)
   Check of operation of the lever of the selector (A4AF3)
   Adjustment of the switch of indication of position of the lever of the selector (A4AF3)
   Check of components of an automatic transmission (F4A42)
   Testing of collaboration of an automatic transmission and the engine on the motionless car (F4A42)
   Check of pressure of transmission liquid (F4A42)
   Check of pressure of transmission liquid (А4AF3)
   Diagnostics function
   Diagnostic codes
   Adjustment of an axial gap of a reactionary brake (F4A42)
   Adjustment of an axial gap of a brake of the second transfer (F4A42)
   Adjustment of an axial gap of a brake of low transfer and transfer of a backing (F4A42)
   Adjustment of an axial gap of a solar gear wheel of lowering transfer (F4A42)
   Adjustment of preliminary loading of differential (F4A42)
   Elements of system of hydraulic management
   Identification of bearings of an automatic transmission of F4A42
   Control lamp of malfunctions (MIL)
   Identification of bearings of an automatic transmission of F4A43
   Adjustment of the servo-driver of compulsory inclusion of a low gear (А4АF3)
   Pressure adjustment in the highway (А4АF3)
   Replacement of an oil sealing ring of a power shaft
   Removal and installation of a transmission of F4A42
   Removal and installation of a transmission of A4AF3
   Management of an automatic transmission
   Interlock installation
   Installation of the device of blocking of a key
+ Power shafts, forward and back axes
+ Suspension bracket
+ Steering
+ Brake system
+ Body
+ air Central air
+ Electric equipment
Electric circuits



Pressure adjustment in the highway (А4АF3)

 PERFORMANCE ORDER

  1. Merge transmission liquid from an automatic transmission.
  1. Remove the oil pallet.
  1. Remove the oil filter.
  1. Remove the sensor of temperature of transmission liquid.
  1. Press a clamp and extend a sealing ring of the electromagnetic valve.
  1. Remove valve knot, thus be careful, that it did not fall.
  1. Turn the adjusting screw of the distributor so that pressure in the highway reached demanded value. Screw rotation clockwise leads to reduction of pressure and, on the contrary, counter-clockwise – to increase. Nominal pressure: 860–900 kPas. Pressure change at screw turn on 1 turn: 38 kPas.
  1. Check that the sealing ring is established on the top part of the case of the valve.
  2. Replace a sealing ring of the electromagnetic valve.
  1. Establish the valve case in a case and insert the socket of the electromagnetic valve into a case. Be convinced that the gear part of the socket is established how is shown in drawing.
  1. Tighten bolts of fastening of the case the moment of an inhaling of 10-12 N • m.
  1. Establish the oil filter.
  1. Establish new laying of the oil pallet and the oil pallet.
  2. Fill in demanded amount of transmission liquid in an automatic transmission.
  3. Check pressure in the highway.