Hyundai Elantra

since 2000-2004 of release

Repair and car operation



Elantr's Hyundai
+ Petrol engines 1,6, 1,8 and 2,0 of l
+ Diesel engine of 2,0 l
+ greasing System
+ cooling System
- Fuel system
   - Fuel system of petrol engines
      Specifications
      Search and elimination of malfunctions
      Check of frequency of rotation of idling
      Check of the fuel pump
      Replacement of the fuel filter
      Replacement of the limiter of overflow (the double-thread valve)
      Fuel level sensor replacement
      Checks of system of injection of MFI
      Control lamp of malfunctions (MIL)
      Diagnostic codes of malfunctions
      Sensors
      Fuel nozzles
      Modulator of management of frequency of rotation of a cranked shaft of the engine idling (ISC)
      Sensor of speed of the car (VSS)
      Sensor of a detonation (KS)
      The lock of ignition (ST) and the switch of ranges (TR) in cars with an automatic transmission
      The lock of ignition (ST) in cars with a mechanical transmission
      Control unit engine
      Switch and relay of central air of air
      Electromagnetic valve of cleaning of the canister of system of catching паров fuels (EVAP)
      Main MFI relay
      Ignition coil
      Fuel pump
      Sensor of acceleration of APS
      Oil valve (OCV)
      Fuel highway and nozzles
      Throttle knot
      Fuel tank
      Pedal and accelerator cable
   + Fuel system of diesel engines
+ Monitoring systems and decrease in toxicity of the fulfilled gases
+ ignition System
+ System of preliminary heating of the diesel engine
+ Coupling
+ Mechanical transmission
+ Automatic transmission
+ Power shafts, forward and back axes
+ Suspension bracket
+ Steering
+ Brake system
+ Body
+ air Central air
+ Electric equipment
Electric circuits



Throttle knot

Removal

The butterfly valve should not act in film Remove the sensor of provision of a butterfly valve.

Removal of the sensor of provision of a butterfly valve carry out only for its replacement.

Check

 PERFORMANCE ORDER

    Check throttle knot on lack of cracks. Check purity of vacuum channels.
    Check люфт an accelerator cable.
  1. The adjusting screw of a butterfly valve was adjusted on lines with air volume 0,516±5 in g % / with therefore it is not recommended to regulate it independently.
  2. If frequency of idling does not correspond demanded, first of all, check the corresponding sensors.
  3. It is not required to clear a deposit in throttle knot as it does not influence at all operability of fuel system.