Hyundai Elantra

since 2000-2004 of release

Repair and car operation



Elantr's Hyundai
+ Petrol engines 1,6, 1,8 and 2,0 of l
+ Diesel engine of 2,0 l
+ greasing System
+ cooling System
+ Fuel system
+ Monitoring systems and decrease in toxicity of the fulfilled gases
+ ignition System
+ System of preliminary heating of the diesel engine
+ Coupling
+ Mechanical transmission
+ Automatic transmission
+ Power shafts, forward and back axes
+ Suspension bracket
+ Steering
- Brake system
   Specifications
   Check of the vacuum amplifier of brakes
   Check of the unilateral vacuum valve
   Pumping of hydraulic system of a drive of brakes
   Adjustment of a course of the parking brake
   Brake pedal
   Vacuum amplifier of brakes
   Main brake cylinder
   Replacement of forward brake shoes
   Support of a forward brake
   Back disk brakes
   Back drum-type brakes
   Replacement of the working brake cylinder
   Pressure regulator
   Brake tubes and hoses
   Parking brake
   Anti-blocking system of brakes (ABS)
   Hydraulic HECU block
   Sensor of frequency of rotation of a wheel
   Pumping of hydraulic system of a drive of brakes with scanner use
   Search and elimination of malfunctions
+ Body
+ air Central air
+ Electric equipment
Electric circuits



Parking brake

Removal

 PERFORMANCE ORDER

  1. Remove the back console.
  1. Unscrew an adjusting nut and disconnect a cable of the parking brake.
  1. Remove the switch of the parking brake.
  2. Remove knot of the lever of the parking brake.
  3. Remove a wheel.
  4. Remove a brake drum.
  5. Remove brake shoes.
  1. Disconnect a cable of the parking brake from the lever on a brake shoe.
  1. Remove a clip, fixing a cover of a cable of the parking brake to a brake board.
  1. Weaken clips of fastening of a cable of the parking brake and remove it from the car.

Check

 PERFORMANCE ORDER

  1. Check operation of the switch of the parking brake.
  2. Check a ratchet of the lever of the parking brake on lack of wear.
  3. Check a cable of the parking brake on lack of wear or damages.

Installation

 PERFORMANCE ORDER

  1. Check marking existence on the left and right cables of the parking brake and establish them on the places.

Identification color:

Left side: Red color
Right side: Yellow color

  1. Move the lever of the parking brake on a brake shoe completely back and establish springs.
  1. Establish a cable of the parking brake in the direction shown in drawing.
  1. Grease with the recommended greasing a ratchet and a doggie of a ratchet of the lever of the parking brake.
    The recommended lubricant: SAE J310, NLGI No. 2.
  2. After installation of the jack adjust a course of the lever of the parking brake.

After a jack arrangement at distance of 40 mm from the lever, manually pull cables and screw an adjusting nut in situation at which the course of the lever of the parking brake will be equal to 8 clicks.