Elantr's Hyundai
+ Petrol engines 1,6, 1,8 and 2,0 of l
+ Diesel engine of 2,0 l
+ greasing System
+ cooling System
+ Fuel system
+ Monitoring systems and decrease in toxicity of the fulfilled gases
+ ignition System
+ System of preliminary heating of the diesel engine
+ Coupling
+ Mechanical transmission
+ Automatic transmission
+ Power shafts, forward and back axes
+ Suspension bracket
+ Steering
- Brake system
Specifications
Check of the vacuum amplifier of brakes
Check of the unilateral vacuum valve
Pumping of hydraulic system of a drive of brakes
Adjustment of a course of the parking brake
Brake pedal
Vacuum amplifier of brakes
Main brake cylinder
Replacement of forward brake shoes
Support of a forward brake
Back disk brakes
Back drum-type brakes
Replacement of the working brake cylinder
Pressure regulator
Brake tubes and hoses
Parking brake
Anti-blocking system of brakes (ABS)
Hydraulic HECU block
Sensor of frequency of rotation of a wheel
Pumping of hydraulic system of a drive of brakes with scanner use
Search and elimination of malfunctions
+ Body
+ air Central air
+ Electric equipment
Electric circuits
|
Replacement of the working brake cylinder
|
|
Remove brake shoes.
Disconnect a brake tube.
|
|
Turn out bolts and remove the working brake cylinder.
|
Remove dustproof covers from the working brake cylinder.
Remove the piston.
Before assembly of the working brake cylinder check a condition of the following details:
– the cylinder and the piston on lack of wear, damages and a rust;
– the case of the working brake cylinder on absence of damages and cracks;
– a contact surface of the piston and brake shoes on lack of wear;
– the piston on lack of internal porosity.
Assembly is carried out in sequence, return dismantling.
|
|
|
|
- Before assembly clear the working brake cylinder isopropyl alcohol.
- Before assembly grease with brake liquid the piston and the cylinder.
- At assembly it is necessary to use new cuffs and dustproof covers.
|
|
|
Be careful not to lose a steel ball of the drainage valve. |
|
|