Hyundai Elantra

since 2000-2004 of release

Repair and car operation


Elantr's Hyundai
+ Petrol engines 1,6, 1,8 and 2,0 of l
+ Diesel engine of 2,0 l
+ greasing System
+ cooling System
+ Fuel system
+ Monitoring systems and decrease in toxicity of the fulfilled gases
+ ignition System
+ System of preliminary heating of the diesel engine
+ Coupling
+ Mechanical transmission
+ Automatic transmission
+ Power shafts, forward and back axes
+ Suspension bracket
+ Steering
- Brake system
   Specifications
   Check of the vacuum amplifier of brakes
   Check of the unilateral vacuum valve
   Pumping of hydraulic system of a drive of brakes
   Adjustment of a course of the parking brake
   Brake pedal
   Vacuum amplifier of brakes
   Main brake cylinder
   Replacement of forward brake shoes
   Support of a forward brake
   Back disk brakes
   Back drum-type brakes
   Replacement of the working brake cylinder
   Pressure regulator
   Brake tubes and hoses
   Parking brake
   Anti-blocking system of brakes (ABS)
   Hydraulic HECU block
   Sensor of frequency of rotation of a wheel
   Pumping of hydraulic system of a drive of brakes with scanner use
   Search and elimination of malfunctions
+ Body
+ air Central air
+ Electric equipment
Electric circuits


Back drum-type brakes

Removal

 PERFORMANCE ORDER

    Remove a wheel.
    Unscrew a nut of fastening of the bearing of a back wheel and remove a nave with a brake drum.
    Remove the bottom returnable spring, a clip and a spring of support of a brake shoe.
    Remove brake shoes together with a regulator.

Check

 PERFORMANCE ORDER

    Measure internal diameter of a brake drum. The indicator of hour type check palpation of a brake drum. Replace a brake drum if internal diameter of a drum exceeds maximum permissible value.

Nominal diameter: 203,2 mm
Maximum diameter: 205,2 mm
Palpation of a brake drum: 0,05 mm
    Measure thickness of overlays of back brake shoes. Replace all brake shoes on one axis of the car even if only one block has thickness, smaller maximum permissible.

Thickness of overlays of brake shoes: 4,5 mm
Minimum admissible thickness of overlays of brake shoes: 1,0 mm

    Check uniformity of a prileganiye of a brake shoe to a brake drum. Examine working brake cylinders on absence of leakages of brake liquid.
    Examine a brake board on lack of wear or damages.

Installation

 PERFORMANCE ORDER

    With greasing grease the following points of contact of brake shoes:
    – points of contact of brake shoes with a brake board;
    – points of contact of brake shoes with a basic plate.

The recommended lubricant: SAE J310, NLGI No. 2.

    Establish a rack of support of a brake shoe.
    Establish returnable springs on brake shoes.
    After installation of a brake drum several times tighten the lever of the parking brake.