Hyundai Elantra

since 2000-2004 of release

Repair and car operation



Elantr's Hyundai
+ Petrol engines 1,6, 1,8 and 2,0 of l
+ Diesel engine of 2,0 l
+ greasing System
+ cooling System
+ Fuel system
+ Monitoring systems and decrease in toxicity of the fulfilled gases
+ ignition System
+ System of preliminary heating of the diesel engine
+ Coupling
+ Mechanical transmission
+ Automatic transmission
+ Power shafts, forward and back axes
+ Suspension bracket
+ Steering
- Brake system
   Specifications
   Check of the vacuum amplifier of brakes
   Check of the unilateral vacuum valve
   Pumping of hydraulic system of a drive of brakes
   Adjustment of a course of the parking brake
   Brake pedal
   Vacuum amplifier of brakes
   Main brake cylinder
   Replacement of forward brake shoes
   Support of a forward brake
   Back disk brakes
   Back drum-type brakes
   Replacement of the working brake cylinder
   Pressure regulator
   Brake tubes and hoses
   Parking brake
   Anti-blocking system of brakes (ABS)
   Hydraulic HECU block
   Sensor of frequency of rotation of a wheel
   Pumping of hydraulic system of a drive of brakes with scanner use
   Search and elimination of malfunctions
+ Body
+ air Central air
+ Electric equipment
Electric circuits



Pressure regulator

The regulator of pressure regulates pressure in a drive of brake mechanisms of back wheels depending on load of a back axis of the car. With increase in loading it provides passing of brake liquid to wheel cylinders of back brakes from what pressure in their contour raises and overall performance of back brake mechanisms improves. Do not assort a pressure regulator.

Check of function of restriction of pressure

 PERFORMANCE ORDER

  1. Remove a pressure regulator from the main brake cylinder.
  2. Connect two manometers, one – on the entrance party and one – on the party of an exit of a regulator of pressure.

After connection of manometers remove air from brake system.

  1. Press a pedal of a brake and measure entrance and target pressure.

If pressure are in limits of admissible amplitudes, as is shown in drawing, the regulator of pressure is serviceable.

  1. Remove manometers and connect tubes of brake system in initial situation and remove air from brake system.

Installation of a regulator of pressure

 PERFORMANCE ORDER

  1. Establish the main brake cylinder.
  1. Tighten connecting nuts of fastening of tubes and remove air from brake system.

Moment of an inhaling of connecting nuts: 13–17 N • m
Moment of an inhaling of nuts of fastening of a regulator of pressure: 35–55 N • m