Elantr's Hyundai
- Petrol engines 1,6, 1,8 and 2,0 of l
Compression check
Gear belt
Adjustment of a tension of a gear belt
Adjustment of a tension of a poliklinovy belt
Adjustment of a tension of a belt of a drive of the generator
Camshafts
Check and adjustment of gaps of valves on engines 1,8 and 2,0 of l (MLA)
Hydraulic jacks of gaps of valves of the engine of 1,6 l
Installation of a cover of a head of cylinders
Directing to a chain
Chain
Installation of camshafts
The mechanism of change of the moment of opening and closing of valves (CVVT) on l engines 1,8 and 2,0
Repair of a head of cylinders
Engine support
Removal and engine and transmission installation
Block of cylinders
Cranked shaft
Flywheel
Piston
Air filter (ACL)
Final collector
Inlet collector
System of production of the fulfilled gases
Search and elimination of malfunctions
+ Diesel engine of 2,0 l
+ greasing System
+ cooling System
+ Fuel system
+ Monitoring systems and decrease in toxicity of the fulfilled gases
+ ignition System
+ System of preliminary heating of the diesel engine
+ Coupling
+ Mechanical transmission
+ Automatic transmission
+ Power shafts, forward and back axes
+ Suspension bracket
+ Steering
+ Brake system
+ Body
+ air Central air
+ Electric equipment
Electric circuits
|
Adjustment of a tension of a poliklinovy belt
|
|
Check a condition of a poliklinovy belt and its arrangement on pulleys.
|
|
Check a belt tension, having pressed on it effort of 100 N in a place located on identical removal from pulleys and measure a belt deflection.
|
|
|
- Check correctness of an arrangement of edges of a poliklinovy belt in flutes of pulleys.
- If at work poliklinovy the belt publishes extraneous noise, check a belt on lack of wear and damages, and also working surfaces of pulleys.
|
|
|
- The tension of a belt should be measured precisely on the center between pulleys.
- When the new belt is established, regulate a tension to the average value given in the column "New". The belt which was in the use considered the belt which has worked on the engine more than 5 mines and its tension it is necessary to regulate to the average value given in a column «Being in the use».
- At adjustment of a tension of the belt which was in the use or the belt which has worked on the engine more than 5 mines it is necessary to regulate its tension to the average value given in a column «Being in the use».
- At periodic surveys it is necessary to be guided by the column "Check".
|
Tension measurement by the special device of type A
|
|
At measurement of a tension of a poliklinovy belt the device should not concern other elements of the engine.
|
Tension measurement by the special device of type B
At measurement be convinced that turned the button of repeated installation in the arrow direction to establish an arrow of the device in an initial condition.
After removal of the device from a belt of the shooter of the device will still specify a belt tension.
|
|
|
Appointment
|
Check
|
Adjustment
|
|
The new
|
Being in the use
|
| Belt of a drive of the generator |
Deflection, mm |
5,1–6,0
|
4,0–4,4
|
5,1–5,7
|
| Tension, N |
350–500
|
650–750
|
400–500
|
Drive belt
conditioner compressor |
Deflection, mm |
800 %
|
5,0–5,5
|
6,0–7,0
|
| Tension, N |
250–500
|
470–570
|
320–400
|
| Belt of a drive of the pump of the amplifier of a steering |
Deflection, mm |
6,0–9,0
|
–
|
–
|
|
|