Hyundai Elantra

since 2000-2004 of release

Repair and car operation



Elantr's Hyundai
- Petrol engines 1,6, 1,8 and 2,0 of l
   Compression check
   Gear belt
   Adjustment of a tension of a gear belt
   Adjustment of a tension of a poliklinovy belt
   Adjustment of a tension of a belt of a drive of the generator
   Camshafts
   Check and adjustment of gaps of valves on engines 1,8 and 2,0 of l (MLA)
   Hydraulic jacks of gaps of valves of the engine of 1,6 l
   Installation of a cover of a head of cylinders
   Directing to a chain
   Chain
   Installation of camshafts
   The mechanism of change of the moment of opening and closing of valves (CVVT) on l engines 1,8 and 2,0
   Repair of a head of cylinders
   Engine support
   Removal and engine and transmission installation
   Block of cylinders
   Cranked shaft
   Flywheel
   Piston
   Air filter (ACL)
   Final collector
   Inlet collector
   System of production of the fulfilled gases
   Search and elimination of malfunctions
+ Diesel engine of 2,0 l
+ greasing System
+ cooling System
+ Fuel system
+ Monitoring systems and decrease in toxicity of the fulfilled gases
+ ignition System
+ System of preliminary heating of the diesel engine
+ Coupling
+ Mechanical transmission
+ Automatic transmission
+ Power shafts, forward and back axes
+ Suspension bracket
+ Steering
+ Brake system
+ Body
+ air Central air
+ Electric equipment
Electric circuits



Compression check

If the engine works badly or with interruptions, check system of ignition and fuel system. If it was not possible to find the reason of bad operation of the engine, inspect a compression.

Regular carrying out this check will allow you to prevent emergence of malfunctions in advance also.

 PERFORMANCE ORDER

    Check level of engine oil. Be convinced that the starter works normally, and the storage battery is completely charged. Start the engine and warm up it to temperature 80–95°C. Switch off the engine and remove from spark plugs tips of high-voltage wires. Turn out spark plugs. Turn a cranked shaft of the engine.
    Screw a tip компрессометра in a spark plug opening.
    Completely open a butterfly valve. Starter turn a cranked shaft of the engine approximately on 4 turnovers and of a scale of the device define a compression. Compression: 1500 kpa Minimum admissible compression: 1400 kpa. Repeat steps 6–8 on other cylinders, having convinced that difference of pressure for each of cylinders is in admissible limits. Admissible difference of pressure in engine cylinders: 100 kpa. If a compression low in all cylinders, through openings for spark plugs fill in in cylinders on нескольку a thaw of engine oil and repeat steps 6–9.
      If filling of oil lifts a compression, probably, piston rings are worn-out. If the compression remains at the same level, probably, valves burned through or laying of a head of cylinders is damaged. Screw spark plugs and connect to them high-voltage wires. Moment of an inhaling of spark plugs: 20–30 N • m