Hyundai Elantra

since 2000-2004 of release

Repair and car operation



Elantr's Hyundai
- Petrol engines 1,6, 1,8 and 2,0 of l
   Compression check
   Gear belt
   Adjustment of a tension of a gear belt
   Adjustment of a tension of a poliklinovy belt
   Adjustment of a tension of a belt of a drive of the generator
   Camshafts
   Check and adjustment of gaps of valves on engines 1,8 and 2,0 of l (MLA)
   Hydraulic jacks of gaps of valves of the engine of 1,6 l
   Installation of a cover of a head of cylinders
   Directing to a chain
   Chain
   Installation of camshafts
   The mechanism of change of the moment of opening and closing of valves (CVVT) on l engines 1,8 and 2,0
   Repair of a head of cylinders
   Engine support
   Removal and engine and transmission installation
   Block of cylinders
   Cranked shaft
   Flywheel
   Piston
   Air filter (ACL)
   Final collector
   Inlet collector
   System of production of the fulfilled gases
   Search and elimination of malfunctions
+ Diesel engine of 2,0 l
+ greasing System
+ cooling System
+ Fuel system
+ Monitoring systems and decrease in toxicity of the fulfilled gases
+ ignition System
+ System of preliminary heating of the diesel engine
+ Coupling
+ Mechanical transmission
+ Automatic transmission
+ Power shafts, forward and back axes
+ Suspension bracket
+ Steering
+ Brake system
+ Body
+ air Central air
+ Electric equipment
Electric circuits


Смотрите здесь калькулятор стоимости создания сайта.

Block of cylinders

Removal

 PERFORMANCE ORDER

    Remove a head of cylinders, a gear belt, a forward cover, a flywheel, pistons and a cranked shaft. The special adaptation (09260-32000) turn out the sensor of pressure of oil.

Check

Block of cylinders

 PERFORMANCE ORDER

    Remove from the block of cylinders of the engine the remains of laying, hermetic, dirt, oil, lubricant and other alien materials. Visually check the block of cylinders on lack of a rust, corrosion, cracks and other defects.
    Clear interfaced surfaces of a head of the block of cylinders and the block of cylinders of the laying remains. A metal ruler and shchupy in six directions check planeness of an interfaced surface of the block of cylinders.

Deviation from planeness: 0,03 mm
Maximum permissible deviation from planeness: 0,1 mm

    Measure diameters of cylinders in the opposite directions, in three planes on height of cylinders. If diameters of cylinders exceed admissible values, have ovality or a konusnost or a surface of cylinders is damaged or has development, the block of cylinders it is necessary to chisel and establish new pistons and piston rings of the repair size.

Nominal diameter of the cylinder: 82 mm
Cylinder Konusnost: no more than 0,01 mm

    If in the top part of the cylinder there is a step, cut off it the special tool. As spare parts pistons of four increased sizes are delivered: 0,25, 0,5, 0,75 and 1,00 mm. When boring cylinders till the next increased size sustain a gap between the piston and the cylinder and be convinced that pistons have the same increased size. Measure external diameter of each piston at distance of 47 mm from a piston skirt.

Gap between the piston and the cylinder:

- l engines 1,8 and 2,0: 0,02–0,04 mm;
- engines of 1,6 l: 0,025–0,045 mm.

    When using new details the maximum gap no more than 85 microns is allowed.