Elantr's Hyundai
+ Petrol engines 1,6, 1,8 and 2,0 of l
+ Diesel engine of 2,0 l
+ greasing System
+ cooling System
+ Fuel system
+ Monitoring systems and decrease in toxicity of the fulfilled gases
+ ignition System
+ System of preliminary heating of the diesel engine
+ Coupling
+ Mechanical transmission
+ Automatic transmission
+ Power shafts, forward and back axes
+ Suspension bracket
+ Steering
+ Brake system
+ Body
- Air central air
Specifications
Instruction on coolant application
Remarks at replacement of elements of central air of air
Connection of elements of central air of air
Precautionary measures
Installation of manometers for pressure measurement
Discharge of central air of air
Pumping of atmospheric air from central air
Connection of the final valve to a cylinder with a coolant
Charging of central air of air
Verification of operational characteristics
Oil for greasing of the compressor of the conditioner
Check and adjustment of a tension of poliklinovy belts
Conditioner compressor
Plug of coupling and pulley of the compressor of the conditioner
Coil of initiation of coupling
Check of a gap of coupling
Fan, condenser and relay
Dryer receiver
Sensor of threefold (double) pressure
Heating and ventilation block
Fan
Air filter
Drive of a zaslonka of supply of fresh / retsirkuliruyemy air
Check of the engine of the fan
Relay check
+ Electric equipment
Electric circuits
|
Precautionary measures
Before separation of elements of central air of air it is necessary to prepare tools and adaptations for service of system so that to leave disconnected system elements on as smaller time is possible.
At separation of components of central air of air immediately close connections by the corresponding covers for an exception of hit of moisture in system.
All spare elements and tubes of central air of air should be stored in tight packing.
Repeatedly do not bend earlier formed tubes.
All tools, the coolant distributing a collector, measuring devices and tubes should be stored in a dry and pure place.
|
|