Hyundai Elantra

since 2000-2004 of release

Repair and car operation



Elantr's Hyundai
+ Petrol engines 1,6, 1,8 and 2,0 of l
+ Diesel engine of 2,0 l
+ greasing System
+ cooling System
+ Fuel system
+ Monitoring systems and decrease in toxicity of the fulfilled gases
+ ignition System
+ System of preliminary heating of the diesel engine
+ Coupling
+ Mechanical transmission
+ Automatic transmission
+ Power shafts, forward and back axes
+ Suspension bracket
+ Steering
+ Brake system
+ Body
- Air central air
   Specifications
   Instruction on coolant application
   Remarks at replacement of elements of central air of air
   Connection of elements of central air of air
   Precautionary measures
   Installation of manometers for pressure measurement
   Discharge of central air of air
   Pumping of atmospheric air from central air
   Connection of the final valve to a cylinder with a coolant
   Charging of central air of air
   Verification of operational characteristics
   Oil for greasing of the compressor of the conditioner
   Check and adjustment of a tension of poliklinovy belts
   Conditioner compressor
   Plug of coupling and pulley of the compressor of the conditioner
   Coil of initiation of coupling
   Check of a gap of coupling
   Fan, condenser and relay
   Dryer receiver
   Sensor of threefold (double) pressure
   Heating and ventilation block
   Fan
   Air filter
   Drive of a zaslonka of supply of fresh / retsirkuliruyemy air
   Check of the engine of the fan
   Relay check
+ Electric equipment
Electric circuits



Verification of operational characteristics


 PERFORMANCE ORDER

  1. Establish a manometer to the highway.
  2. Start the engine, leave to work at frequency of rotation of a cranked shaft of 2000 mines–1 and establish a mode of the maximum cooling at high frequency of rotation of the fan.
  3. Open all windows or doors.
  4. Establish the thermometer in a lattice of supply of air in car salon.
  1. Establish damp and dry thermometers as it is possible closer to an entrance opening of the block of cooling.
  1. Check that the pressure shown by a manometer, is in limits of 1,373-1,575 kPas. If pressure too high, pour water on the condenser. If pressure too low, close the forward party of the condenser.
  2. Check that air temperature in a lattice of supply of air in salon of the car is in limits 25–35°C.
  3. According to the schedule calculate relative humidity of air, comparing temperature of damp and dry thermometers.
  4. Take temperature in a lattice of supply of air in salon of the car and calculate a difference the dry thermometer and the thermometer in a lattice of supply of air.
  1. Check that if crossing of relative humidity and a difference of temperatures are in admission limits, means, central air of air works normally.