Elantr's Hyundai
+ Petrol engines 1,6, 1,8 and 2,0 of l
+ Diesel engine of 2,0 l
+ greasing System
+ cooling System
+ Fuel system
+ Monitoring systems and decrease in toxicity of the fulfilled gases
+ ignition System
+ System of preliminary heating of the diesel engine
+ Coupling
+ Mechanical transmission
+ Automatic transmission
+ Power shafts, forward and back axes
+ Suspension bracket
+ Steering
+ Brake system
+ Body
- Air central air
Specifications
Instruction on coolant application
Remarks at replacement of elements of central air of air
Connection of elements of central air of air
Precautionary measures
Installation of manometers for pressure measurement
Discharge of central air of air
Pumping of atmospheric air from central air
Connection of the final valve to a cylinder with a coolant
Charging of central air of air
Verification of operational characteristics
Oil for greasing of the compressor of the conditioner
Check and adjustment of a tension of poliklinovy belts
Conditioner compressor
Plug of coupling and pulley of the compressor of the conditioner
Coil of initiation of coupling
Check of a gap of coupling
Fan, condenser and relay
Dryer receiver
Sensor of threefold (double) pressure
Heating and ventilation block
Fan
Air filter
Drive of a zaslonka of supply of fresh / retsirkuliruyemy air
Check of the engine of the fan
Relay check
+ Electric equipment
Electric circuits
|
Plug of coupling and pulley of the compressor of the conditioner
Removal
|
|
|
|
Turn out a bolt of fastening of the plug of the coupling, thus a special key 09977–34000 hold the plug from a provorachivaniye.
|
Remove the coupling and laying plug from a compressor shaft. If the plug does not act in film, screw a bolt on М8 in an opening of a shaft of the plug and for a bolt remove the plug.
Remove a lock ring.
Remove a pulley and the bearing from a compressor shaft.
|
|
Installation
|
|
Clear a working surface of the bearing of a pulley of the compressor and remove dirt and corrosion traces.
Establish a pulley and the bearing on a compressor shaft.
Establish a lock ring the slanted party directed outside.
|
|
Arrange one laying of the rasporny plug of nominal thickness in a flute of the plug and establish the plug on a compressor shaft.
|
|
|
Establish the new plug and fix it a bolt, having tightened it the demanded moment. Inhaling moment: 11–14 N • m.
|
|
|
|
|
Do not use pneumatic tools. |
|
|