Hyundai Elantra

since 2000-2004 of release

Repair and car operation


Elantr's Hyundai
+ Petrol engines 1,6, 1,8 and 2,0 of l
+ Diesel engine of 2,0 l
+ greasing System
+ cooling System
+ Fuel system
+ Monitoring systems and decrease in toxicity of the fulfilled gases
+ ignition System
+ System of preliminary heating of the diesel engine
+ Coupling
+ Mechanical transmission
+ Automatic transmission
+ Power shafts, forward and back axes
+ Suspension bracket
+ Steering
+ Brake system
+ Body
- Air central air
   Specifications
   Instruction on coolant application
   Remarks at replacement of elements of central air of air
   Connection of elements of central air of air
   Precautionary measures
   Installation of manometers for pressure measurement
   Discharge of central air of air
   Pumping of atmospheric air from central air
   Connection of the final valve to a cylinder with a coolant
   Charging of central air of air
   Verification of operational characteristics
   Oil for greasing of the compressor of the conditioner
   Check and adjustment of a tension of poliklinovy belts
   Conditioner compressor
   Plug of coupling and pulley of the compressor of the conditioner
   Coil of initiation of coupling
   Check of a gap of coupling
   Fan, condenser and relay
   Dryer receiver
   Sensor of threefold (double) pressure
   Heating and ventilation block
   Fan
   Air filter
   Drive of a zaslonka of supply of fresh / retsirkuliruyemy air
   Check of the engine of the fan
   Relay check
+ Electric equipment
Electric circuits


Instruction on coolant application

    Liquid coolant R–134a with the high content of flying substances. Its hit on skin can end with frostbite therefore at work with a coolant it is necessary to put on protective gloves. As standard measures of protection at work with a coolant it is necessary to use points for protection of eyes. At coolant hit on clothes or protective equipment immediately wash out the struck place a large amount of water. Liquid coolant R–134a is stored in containers (cylinders). Store a cylinder with a coolant at temperature no more 52°C. For check of tightness of central air use the electronic sensor. Keep in mind that coolant R–134a after contact to a flame decays with allocation of very poisonous gas. Use only the recommended oil for greasing of elements of central air of air as, otherwise, the system can fail. PAG greasing intensively absorbs moisture from atmospheric air therefore it is necessary to observe the following precautions:
    – at separation of components of central air of air immediately close connections by the corresponding covers for an exception of hit of moisture in system;
    – at installation of new components of central air of air remove from them protective covers directly ahead of their installation;
    – connect tubes and hoses of central air of air as soon as possible to reduce hit in moisture system;
    – use greasing for air central air only from the tight container. If there was a casual discharge of central air of air, before service of system air a workplace.