Hyundai Elantra

since 2000-2004 of release

Repair and car operation


Elantr's Hyundai
+ Petrol engines 1,6, 1,8 and 2,0 of l
+ Diesel engine of 2,0 l
+ greasing System
+ cooling System
+ Fuel system
+ Monitoring systems and decrease in toxicity of the fulfilled gases
+ ignition System
+ System of preliminary heating of the diesel engine
+ Coupling
+ Mechanical transmission
+ Automatic transmission
+ Power shafts, forward and back axes
+ Suspension bracket
+ Steering
+ Brake system
+ Body
- Air central air
   Specifications
   Instruction on coolant application
   Remarks at replacement of elements of central air of air
   Connection of elements of central air of air
   Precautionary measures
   Installation of manometers for pressure measurement
   Discharge of central air of air
   Pumping of atmospheric air from central air
   Connection of the final valve to a cylinder with a coolant
   Charging of central air of air
   Verification of operational characteristics
   Oil for greasing of the compressor of the conditioner
   Check and adjustment of a tension of poliklinovy belts
   Conditioner compressor
   Plug of coupling and pulley of the compressor of the conditioner
   Coil of initiation of coupling
   Check of a gap of coupling
   Fan, condenser and relay
   Dryer receiver
   Sensor of threefold (double) pressure
   Heating and ventilation block
   Fan
   Air filter
   Drive of a zaslonka of supply of fresh / retsirkuliruyemy air
   Check of the engine of the fan
   Relay check
+ Electric equipment
Electric circuits


Conditioner compressor

Elements of the compressor of the conditioner

1–the compressor with the coupling
2–compressor
3–cylinder and shaft
4–forward cylinder
5–back cylinder
6–plug
7–ring of A of the bearing
8–bearing
9–ring of the L bearing
10-a disk established at an angle to a shaft
11-shaft
12-block
13-piston
14-ring Е of the bearing
15-spring
16-entrance plate
17-block of a forward plate
18-forward plate
19-hairpin
20-block of a back plate
21-back plate
22-unloading element
23-forward laying
24-back laying
25-sealing ring
26-back section of the compressor

27-forward section of the compressor
28-bolt
29-flat washer
30-shaft consolidation
31-ring
32-1-consolidation
32-2-adjusting plug
32-3-adjusting plug
33-excitement coil
34-pulley
35-disk and nave
36-ring
37-laying
38-bolt
39-screw
40-socket arm
41-collector knot
42-collector
43-absorption branch pipe
44-discharge branch pipe
45-safety valve
46-sealing ring of round section
47-hairpin
48-bolt
49-wrench
50-laying


Removal and installation

 PERFORMANCE ORDER

    Weaken a tension and remove a belt of a drive of the compressor of the conditioner.
    Discharge air central air.
    Remove a hose of a discharge and soaking-up hose.
    Remove the conditioner compressor. Immediately close all open openings and tubes for an exception of hit of moisture of air in air central air. Installation is carried out to sequences, return to removal.