Hyundai Elantra

since 2000-2004 of release

Repair and car operation



Elantr's Hyundai
+ Petrol engines 1,6, 1,8 and 2,0 of l
+ Diesel engine of 2,0 l
+ greasing System
+ cooling System
+ Fuel system
+ Monitoring systems and decrease in toxicity of the fulfilled gases
+ ignition System
+ System of preliminary heating of the diesel engine
+ Coupling
+ Mechanical transmission
+ Automatic transmission
+ Power shafts, forward and back axes
- Suspension bracket
   Specifications
   Rack of a forward suspension bracket
   Bottom lever of a forward suspension bracket
   Forward stabilizer of cross-section stability
   Rack of a back suspension bracket
   Cross-section levers of a back suspension bracket
   Longitudinal levers of a back suspension bracket
   Back stabilizer of cross-section stability
   Corners of installation of forward wheels
   Wear of tires
   Shift of wheels
   Check of withdrawal and course instability of the car
   Wheel palpation
   Tightening of nuts of fastening of a wheel
   Search and elimination of malfunctions
   Diagnostics of wear of tires
+ Steering
+ Brake system
+ Body
+ air Central air
+ Electric equipment
Electric circuits



Cross-section levers of a back suspension bracket

Removal

 PERFORMANCE ORDER

  1. Remove a back wheel.
  1. Disconnect draft of the stabilizer of cross-section stability.
  1. Turn out bolts and remove the longitudinal lever of a back suspension bracket.
  1. Turn out a bolt of fastening of cross-section levers of a back suspension bracket to a nave support.
  1. Support a back beam a jack and turn out bolts of fastening of a beam to a body.
  2. Remove a back beam and levers.

Dismantling

 PERFORMANCE ORDER

  1. Establish special tools 09545-28100 and 09545-25000 on the cross-section lever of a back suspension bracket.
  1. Squeeze out the plug from the cross-section lever of a back suspension bracket.

Check

 PERFORMANCE ORDER

  1. Check the plug on lack of wear and condition deterioration.
  2. Check levers on lack of a bend or damage.
  3. Check a condition of all bolts.

Assembly

 PERFORMANCE ORDER

  1. Grease with soap solution the plug and a plug installation site on the lever.
  2. The special tool 09552-25000 press the plug in the lever.

Installation

Installation is carried out to sequences, return to removal.

Tighten all carving connections by the demanded moments.

Inhaling moment:

* Bolts of fastening of the longitudinal lever of a back suspension bracket: 100–120 N • m
Bolts of fastening of an arm of the longitudinal lever of a back suspension bracket: 40–50 N • m
Bolts of fastening of an arm of the stabilizer of cross-section stability: 17–26 N • m
Drafts of the stabilizer of cross-section stability: 35–45 N • m
* Nut of fastening forward / back cross-section levers of a back suspension bracket: 130–150 N • m
Bolts of fastening of a back beam: 100–120 N • m

* carving connections which are necessary for tightening the demanded moment only after car installation on wheels Are noted.