Hyundai Elantra

since 2000-2004 of release

Repair and car operation



Elantr's Hyundai
+ Petrol engines 1,6, 1,8 and 2,0 of l
+ Diesel engine of 2,0 l
+ greasing System
+ cooling System
+ Fuel system
+ Monitoring systems and decrease in toxicity of the fulfilled gases
+ ignition System
+ System of preliminary heating of the diesel engine
- Coupling
   Specifications
   Adjustment of a pedal of coupling
   Pumping of hydraulic system of a drive of coupling
   Conducted and press coupling disks
   Main cylinder of coupling
   Coupling pedal
   Working cylinder of coupling
   Search and elimination of malfunctions
+ Mechanical transmission
+ Automatic transmission
+ Power shafts, forward and back axes
+ Suspension bracket
+ Steering
+ Brake system
+ Body
+ air Central air
+ Electric equipment
Electric circuits



Working cylinder of coupling

Removal

 PERFORMANCE ORDER

    Disconnect a hydraulic tube of coupling. Turn out bolts of fastening of the working cylinder of coupling.

Check

 PERFORMANCE ORDER

    Clear the dismantled details in solvent and blow all details and channels the compressed air. Check the working cylinder of coupling and covers on absence of damages.

Dismantling

 PERFORMANCE ORDER

    Lift the receiver, a valve plate, a spring, a pusher and a cover. Remove dirt from an open opening for connection of a hydraulic tube.
    Remove the piston and a sealing ring (cuff), submitting the compressed air through an opening for connection of a hydraulic tube.
  1. Close an opening of the working cylinder pure rags to catch the piston pushed out by compressed air.
  2. For an exception of a razbryzgivaniye of brake liquid submit air slowly.

Check

 PERFORMANCE ORDER

    Check the working cylinder of coupling on absence of damages. Check covers on absence of damages.
    Measure internal diameter of the main cylinder of coupling. If the gap between the piston and the cylinder exceeds admissible value, replace the main cylinder and / or the piston assembled.

Measurement of internal diameter of the main cylinder of coupling carry out in three sections (in the basis, the center and top) in two perpendicular directions. Gap: 0,15 mm.

Assembly

 PERFORMANCE ORDER

    Before assembly grease with liquid for coupling the piston and diameter of boring of the cylinder and establish the piston assembled. Liquid: brake DOT 3 or DOT 4 liquid.
    Establish a valve plate, a pusher and a cover.

Installation

 PERFORMANCE ORDER

    Before installation grease the plug, a pin, a washer and a pin with a head and an opening under шплинт. Greasing: CASMOLY L9508.
    Establish the cylinder of switching off of coupling and connect to it a hydraulic tube.