Hyundai Elantra

since 2000-2004 of release

Repair and car operation



Elantr's Hyundai
+ Petrol engines 1,6, 1,8 and 2,0 of l
+ Diesel engine of 2,0 l
+ greasing System
+ cooling System
+ Fuel system
+ Monitoring systems and decrease in toxicity of the fulfilled gases
+ ignition System
+ System of preliminary heating of the diesel engine
- Coupling
   Specifications
   Adjustment of a pedal of coupling
   Pumping of hydraulic system of a drive of coupling
   Conducted and press coupling disks
   Main cylinder of coupling
   Coupling pedal
   Working cylinder of coupling
   Search and elimination of malfunctions
+ Mechanical transmission
+ Automatic transmission
+ Power shafts, forward and back axes
+ Suspension bracket
+ Steering
+ Brake system
+ Body
+ air Central air
+ Electric equipment
Electric circuits



Main cylinder of coupling

Dismantling

 PERFORMANCE ORDER

  1. Remove a bandage of fastening of a popolnitelny tank, a tank and a cover.
  2. Remove a lock ring of the piston.
  3. Take a pusher and the piston.

Do not damage a pusher and a surface of the main cylinder of the coupling, contacting to the piston.

Check

 PERFORMANCE ORDER

  1. Clear the dismantled details in solvent and blow all details and channels the compressed air.
  2. Check an internal part of the case of the cylinder on lack of a rust, dot corrosion or development.
  3. Check a piston cuff on lack of wear.
  4. Check the piston on lack of a rust, dot corrosion or development.
  5. Check a tube of a hydraulic drive of coupling on absence of damages.
  6. Measure internal diameter of the main cylinder of coupling.

Measurement of internal diameter of the main cylinder of coupling carry out in three sections (in the basis, the center and top) in two perpendicular directions.

  1. If the gap between the piston and the cylinder exceeds admissible value, replace the main cylinder and/or the piston assembled. Gap: 0,15 mm.

Assembly

 PERFORMANCE ORDER

  1. Before assembly grease with liquid for coupling the piston and diameter of boring of the cylinder. Liquid: brake DOT 3 or DOT 4 liquid.
  2. Establish the piston assembled.
  3. Establish a lock ring of the piston.
  1. Establish a pusher.
  1. Establish a tape of fastening of a popolnitelny tank, a tank and a cover.