Hyundai Elantra

since 2000-2004 of release

Repair and car operation



Elantr's Hyundai
+ Petrol engines 1,6, 1,8 and 2,0 of l
+ Diesel engine of 2,0 l
+ greasing System
+ cooling System
+ Fuel system
+ Monitoring systems and decrease in toxicity of the fulfilled gases
+ ignition System
+ System of preliminary heating of the diesel engine
+ Coupling
+ Mechanical transmission
+ Automatic transmission
- Power shafts, forward and back axes
   Specifications
   Power shaft
   Power shaft with CV JOINTS of ball type and type Birfield
   Power shaft with Birfield CV JOINTS (B. J.) and tripoidny type (T. J.)
   Rotary fist and nave of a forward wheel
   Back axis/nave of a back wheel
   Search and elimination of malfunctions
+ Suspension bracket
+ Steering
+ Brake system
+ Body
+ air Central air
+ Electric equipment
Electric circuits



Back axis/nave of a back wheel

Removal

 PERFORMANCE ORDER

    Weaken nuts of fastening of a back wheel. Lift the car and fix on support. Unscrew nuts and remove a back wheel. Hammer and chisel remove from a nave a cap. Unbend a fillet, unscrew a nut of fastening of a nave of a back wheel and remove a petal washer. Remove the ABS sensor.

At removal of the ABS sensor be careful not to strike a sensor tip about teeths of a rotor or other elements.
    Remove a support and fix it a wire on a rack of a back suspension bracket.
    Remove a brake disk and a nave of a back wheel.
    Turn out the screw and remove a brake disk from a nave of a back wheel.
    Needlessly do not remove the bearing from a nave of a back wheel.
  • Be careful not to damage or to scratch rotor teeths. Exclude rotor falling. If teeths of a rotor are damaged it will break operability of anti-blocking brake system.

Check

 PERFORMANCE ORDER

    Check a sealing ring on lack of wear and damages. Check the bearing of a nave of a back wheel on lack of wear and damages. Check a rotor of the sensor of frequency of rotation of a back wheel on lack of a vykrashivaniye of teeths. Check a nave support on lack of cracks.

Installation

 PERFORMANCE ORDER

    Screw a new nut with a fillet and hammer a nut fillet into a nave groove.
At installation it is necessary to use a new nut with a fillet.
    Establish the ABS sensor. Insert щуп into a gap between the sensor and teeths of a rotor and tighten the sensor in situation in which the demanded gap is provided. ABS sensor gap: 0,2–1,3 mm.
    Establish on a nave a cap.