Elantr's Hyundai
+ Petrol engines 1,6, 1,8 and 2,0 of l
+ Diesel engine of 2,0 l
- Greasing system
Specifications
Check of level of engine oil
Replacement of engine oil
Replacement of the oil filter
Choice of engine oil
Oil pump of petrol engines
Oil pump of diesel engines
Oil radiator of diesel engines
+ cooling System
+ Fuel system
+ Monitoring systems and decrease in toxicity of the fulfilled gases
+ ignition System
+ System of preliminary heating of the diesel engine
+ Coupling
+ Mechanical transmission
+ Automatic transmission
+ Power shafts, forward and back axes
+ Suspension bracket
+ Steering
+ Brake system
+ Body
+ air Central air
+ Electric equipment
Electric circuits
|
Oil pump of diesel engines
Removal
|
|
Remove internal and external gear wheels of the oil pump from a forward cover, previously having noted their mutual situation.
|
Check
|
|
Check lack of wear or damage of teeths of gear wheels of the oil pump.
Check an axial gap of rotors of the oil pump. Axial gap: 0,02–0,07 mm.
By Shchup measure a gap between teeths of rotors of the oil pump. A gap between teeths of rotors of the oil pump: 0,1-0,2 mm.
Check a radial gap of rotors of the oil pump.
|
|
Plunzher and spring
|
|
Check smoothness of moving of a plunzher.
Check a spring on absence of deformation or damages.
|
|
Check of the sensor of pressure of oil
|
|
|
|
Ohmmeter check conductivity of connection between the plug of the sensor and the block of cylinders. In the absence of conductivity, replace the sensor.
|
|
|
Ohmmeter check conductivity of connection between the plug of the sensor and the block of cylinders at the put-forward rod of the sensor. If conductivity is available even at the put-forward rod, replace the sensor.
|
However, if there is no conductivity even at the annex of vacuum of 50 kPas to a sensor opening, the sensor works properly.
|
|
Check of a spray of oil
|
|
Check a spray of oil and the control valve on lack of contaminations.
Check an oil spray on absence of damages and deformation.
|
|
Installation
|
|
Establish an external rotor of the oil pump in a forward cover, previously having combined put before a label.
|
|
Before installation of a rotor grease it with engine oil. |
Using the special tool, screw the sensor of pressure of oil, previously having greased a sensor carving with a hermetic layer.
|
|
Do not tighten the pressure sensor with application of the big moment of an inhaling. |
|
|
|
|