Hyundai Elantra

since 2000-2004 of release

Repair and car operation



Elantr's Hyundai
+ Petrol engines 1,6, 1,8 and 2,0 of l
+ Diesel engine of 2,0 l
- Greasing system
   Specifications
   Check of level of engine oil
   Replacement of engine oil
   Replacement of the oil filter
   Choice of engine oil
   Oil pump of petrol engines
   Oil pump of diesel engines
   Oil radiator of diesel engines
+ cooling System
+ Fuel system
+ Monitoring systems and decrease in toxicity of the fulfilled gases
+ ignition System
+ System of preliminary heating of the diesel engine
+ Coupling
+ Mechanical transmission
+ Automatic transmission
+ Power shafts, forward and back axes
+ Suspension bracket
+ Steering
+ Brake system
+ Body
+ air Central air
+ Electric equipment
Electric circuits



Replacement of the oil filter

All Hyundai engines are equipped with the high-quality, disposable oil filter. This filter is recommended as the replacement filter on all cars. For ensuring normal operation of the engine only high-quality filters should be used.

At replacement of the filter be convinced that rubber laying is completely removed from the old oil filter from a privalochny surface of the block of cylinders.

At replacement of engine oil be careful, as oil hotter and it is possible to burn.

Petrol engines

 PERFORMANCE ORDER

    Special key turn out the oil filter.
    Grease with a thin layer of pure engine oil a rubber sealing ring of the new oil filter.
    Screw the oil filter and tighten it the demanded moment. Inhaling moment: 12–16 N • m.
    Start the engine and check absence of leakages of oil After a stop of the engine check level of oil and, if necessary, finish it to norm.

Diesel engines


 PERFORMANCE ORDER

    Weaken a stopper oil plum with a copper washer and merge a small amount of engine oil from the oil filter.
    Weaken a plastic top cover before emergence of a sealing ring of round section, then completely merge engine oil. (Use a wrench 09263-27100). Remove the top cover. Be convinced that the filtering element of the oil filter is removed together with a plastic top cover. Replace on new filtering element of the oil filter and a sealing ring of round section.
    Tighten the top cover of the oil filter the demanded moment. Inhaling moment: 23–25 N • m.
    Establish on a stopper a new copper washer and screw a stopper in the bottom aluminum cover. Inhaling moment: 8–10 N • m. Start the engine and check absence of leakages of oil. After a stop of the engine check level of oil and, if necessary, finish it to norm.