Hyundai Elantra

since 2000-2004 of release

Repair and car operation

Elantr's Hyundai
+ Petrol engines 1,6, 1,8 and 2,0 of l
+ Diesel engine of 2,0 l
+ greasing System
+ cooling System
+ Fuel system
+ Monitoring systems and decrease in toxicity of the fulfilled gases
+ ignition System
+ System of preliminary heating of the diesel engine
+ Coupling
+ Mechanical transmission
+ Automatic transmission
+ Power shafts, forward and back axes
+ Suspension bracket
+ Steering
+ Brake system
- Body
   Adjustment of hinges of a cowl
   Trunk lid
   Door of a luggage compartment
   Forward door
   Back door
   Roof hatch
   Ceiling furnish
   Internal upholstery of salon
   Front bumper
   Rear bumper
   Sitting lobbies
   Back seat
   Seat belts
   Humeral seat belt of back sitting
   Zone seat belt of back sitting
   Search and elimination of malfunctions
+ air Central air
+ Electric equipment
Electric circuits

Каталог дверных ручек смотрите на


Removal and installation

Door molding

The special tool 09800-21000, since any end of a molding, separate it from a lobby and a back door.

Be careful not to scratch a door.

Roof molding


    By screw-driver edge as the lever, separate the end of a molding of a roof how it is shown in drawing.

To prevent roof damage, wrap up a fabric a screw-driver edge. Be careful not to scratch a body.

    Pull and remove a roof molding. Installation is carried out to sequences, return to removal.

If necessary replace the damaged clips.