Hyundai Elantra

since 2000-2004 of release

Repair and car operation



Elantr's Hyundai
+ Petrol engines 1,6, 1,8 and 2,0 of l
+ Diesel engine of 2,0 l
+ greasing System
+ cooling System
+ Fuel system
+ Monitoring systems and decrease in toxicity of the fulfilled gases
+ ignition System
+ System of preliminary heating of the diesel engine
+ Coupling
+ Mechanical transmission
+ Automatic transmission
+ Power shafts, forward and back axes
+ Suspension bracket
+ Steering
+ Brake system
- Body
   Specifications
   Adjustment of hinges of a cowl
   Trunk lid
   Door of a luggage compartment
   Forward door
   Back door
   Moldings
   Roof hatch
   Console
   Dashboard
   Ceiling furnish
   Internal upholstery of salon
   Front bumper
   Rear bumper
   Sitting lobbies
   Back seat
   Seat belts
   Humeral seat belt of back sitting
   Zone seat belt of back sitting
   Search and elimination of malfunctions
+ air Central air
+ Electric equipment
Electric circuits



Seat belts

Removal and installation

 PERFORMANCE ORDER

    Turn out a bolt of the bottom fastening of a forward seat belt and an edge of a flat screw-driver lift up and remove an upholstery of an average rack. Inhaling moment: 40–55 N • m.
    Turn out a bolt of the top fastening of a forward seat belt. Inhaling moment: 40–55 N • m.
    If the car the equipment preliminary natyazhitel of seat belts, disconnect a wire from the negative plug of the storage battery, disconnect the socket from a gas generator and remove a natyazhitel of a seat belt.
    Installation is carried out to sequences, return to removal.

  1. The module of a prednatyazhitel of a seat belt works only once.
  2. Do not assort and do not repair the module of a prednatyazhitel of a seat belt.
  3. Do not drop the module of a prednatyazhitel of a seat belt and do not allow its contact to water, greasing etc. If dents are found, cracks, deformation or corrosion, replace the module.
  4. Connect a wire to the negative plug of the storage battery only after the correct installation of the module of a prednatyazhitel of a seat belt.
  5. Removal of the module of a prednatyazhitel of a seat belt:
    • Be convinced that ignition is switched off.
    • Disconnect a wire from the negative plug of the storage battery and be convinced that it does not concern a body.
    • Wait 1 minute.
    • Disconnect the electric socket from a gas generator.
    • Turn out a bolt and remove the module of a prednatyazhitel of a seat belt.