Hyundai Elantra

since 2000-2004 of release

Repair and car operation



Elantr's Hyundai
+ Petrol engines 1,6, 1,8 and 2,0 of l
+ Diesel engine of 2,0 l
+ greasing System
+ cooling System
+ Fuel system
+ Monitoring systems and decrease in toxicity of the fulfilled gases
+ ignition System
+ System of preliminary heating of the diesel engine
+ Coupling
+ Mechanical transmission
+ Automatic transmission
+ Power shafts, forward and back axes
+ Suspension bracket
+ Steering
+ Brake system
- Body
   Specifications
   Adjustment of hinges of a cowl
   Trunk lid
   Door of a luggage compartment
   Forward door
   Back door
   Moldings
   Roof hatch
   Console
   Dashboard
   Ceiling furnish
   Internal upholstery of salon
   Front bumper
   Rear bumper
   Sitting lobbies
   Back seat
   Seat belts
   Humeral seat belt of back sitting
   Zone seat belt of back sitting
   Search and elimination of malfunctions
+ air Central air
+ Electric equipment
Electric circuits



Back door

Removal and installation

 PERFORMANCE ORDER

    Turn out the screw of fastening of the internal handle and remove it from a door upholstery.
    Turn out screws of fastening of an upholstery of a door.
    Insert a stripper of an upholstery of a door between an upholstery of a door and a door and release percussion caps. Disconnect electric sockets.
    Remove from a forward door a vlagozashchitny film.
    Lower door glass down and turn out screws of fastening of glass.
    Remove operated glass from a back door.
    Remove the dividing channel from a back door, then remove glass of a back door.
    Remove motionless glass from a back door.
    Disconnect draft from the external handle of a door. Turn out bolts of fastening of the lock and a lock drive.
    Remove the control unit from a back door.
    Installation is carried out to sequences, return to removal. At installation of a vlagozashchitny film openings for fixing elements of an upholstery of a door should not be closed.

Adjustment of provision of a door

Check that the door is closed easily and properly, then check uniformity of gaps between forward and back, top and bottom parts of a door and a body. Doors and sides of a body should be парралельны.

Shock plate of a door

Check that the door is closed easily and properly. If necessary adjust a door as follows.

 PERFORMANCE ORDER

    If the lock of a door is established on a shock plate hardly, turn out screws of fastening of a shock plate and, moving it in the horizontal and vertical planes, achieve normal closing of a door.
    Adjustment of provision of a door of rather adjacent surfaces carry out moving of a shock plate in the vertical plane.

For check of smoothness of landing of a shock plate pull the external handle of a door outside and in this situation press a door in the provision of its closing.