Establish the selector lever in the situation "N".
From a transmission weaken a nut of fastening of a cable of management to the lever, for cable and control lever release.
|
|
Establish the selector lever in neutral situation.
|
|
|
Weaken assembly bolts of fastening of the case of the switch of ranges of a transmission, then turn the case of the switch of ranges of a transmission so that were combined an opening on the end of a control lever and an opening in a ledge of the case of the switch of ranges of a transmission.
|
Tighten assembly bolts of fastening of the case of the switch of ranges of a transmission the moment of the inhaling given in the specification. Be careful, that at a tightening of bolts not to displace the switch case.
Softly press a cable of management of a transmission in the direction of an arrow and then tighten an adjusting nut.
Check that the lever of the selector is in the situation "N".
|
|
Check work and switch functioning for each position of the lever of the selector.
|
|
|